thank you all for the info on adj and things to look for. wired choke and
adjusted cold now i have to let cool to see if it works right. with engine
up to temp i started to adjust screws to about 1 1/2 turns. still runs
about the same. so i started looking for vac. leaks. now when i bought the
car, dpo said that engine had been camed and raced buy his dpo, so rough
idle didn't bother me.( i also bought the car not running)
on heat block under carb, vac hose go's to pcv valve in valve cover, i
pulled this hose and hooked vac gauge there. start engine smooth idle that
i never had before?? pulled out pcv valve no gutts? but now i get oil smoke
blowing out oil fill cap, not a lot but enough to **** me off. also there
was about 11 lbs of vac. on gauge. so what do i do now? any suggestions?
thanks disappointed dan
Alicia & Dan
Windsor, NY
B9471431
B395017486LRX
B395006486LRX
|