Lou,
I bought a set from Tiger Tom about three years ago.
Rob Kempinski
> ----------
> From: louabbot[SMTP:louabbot@mail.ameritel.net]
> Reply To: louabbot
> Sent: Monday, August 10, 1998 9:39 PM
> To: Gary A Winblad; FrizBMG@aol.com
> Cc: tigers@autox.team.net
> Subject: Re: Odds and Ends- Engine critique
>
> Everyone;
> When I took the crossmember off my current project there were NO
> shims. I
> did not realize something was missing until I took of the crossmember
> of my
> second project--lo and behold--shims! Very corroded and useless. I
> read an
> e-mail in the last day or so (must have deleted it-duh) need to find a
> source for them or a drawing in order to make a pair or two. Thanks.
> Lou
>
> ----------
> > From: Gary A Winblad <gary_winblad@juno.com>
> > To: FrizBMG@aol.com
> > Cc: tigers@autox.team.net
> > Subject: Re: Odds and Ends- Engine critique
> > Date: Sunday, August 09, 1998 12:20 AM
> >
> >
> > On Sun, 9 Aug 1998 00:03:35 EDT FrizBMG@aol.com writes:
> > > Hi Tigers
> >
> > Tony
> >
> > >PS.Do the front end shims(the aluminum spacers)between the
> crossmember
> > >and the
> > >frame get installed large side facing front?
> >
> > NO, the large (thick) side is in the back. And they should be
> riveted to
> > the
> > crossmember so you don't have to tape them in place.. think it takes
> two
> > large pop-rivets on each side.
> > Gary
> >
>
|