tiger technologies wrote:
Thanks Jeff, Mark, Allan and Mark for your responses!
I was thinking to get these section made up in 1/8" stainless steel (304
Grade) at a sheet metal shop and replacing the original section, welding in
will not be a problem. Reason for this is I see this point as the most
vulnerable for future corrossion no mater what I do due to the heat and
contact of the exhaust, making it near impossible to protect long term with a
coating.
Regards
Wally
> Wally:
> Call Rick at Sunbeam Specialties. He sells replacement cross members. Look
> like new and are reasonably priced. Good luck.
> Jeff/TT
> At 09:21 PM 7/27/98 +1000, you wrote:
> >A question for those not on holidays in the Northern Sphere.
> >
> >Can anyone in Tigerdom tell me the size of the oval shaped holes that
> >the exhaust pipe goes through the chassis cross members are. Previous
> >Owner obviously thought the clearance was a bit tight so he delicately
> >enlarged them with a gas axe!
> >
> >Cheers
> >Wally Menke
> >B9471793
> >
> >
> >
|