New plug wires were the ticket....although as with everything on the
Tigger, required some modification. Glad several pointed out page 71 of
the shop manual as well!!
As Doug noted, used plenty of Dielectric Silicone at all of the contact
points and routed the wires correctly......back to tip top running
condition. Good news is: Borg-Warner 7mm sprialcore wires were only $24.99
at Pee-Pee Boys!!
Thanks to all for the advice and cautions...
Regards
Allan
B9472373
At 06:36 AM 5/1/98 -0400, Doug & Rett Leithauser wrote:
>Darn near all plug wires work good when you put them on. the problems
>usually come along when you remove them. After being on the plug for a
>while they have pretty well glued themselves in place and tend to self
>destruct when removed. I like to put silicone grease inside the plug boot
>before installation, which helps, but is not a cure all.
>
>Doug Leithauser
>
>
>> What do you think about Spark Plug Wire Sets.
>> The reason I ask is that the PO installed ACCEL spark plug wires.....I
>> suppose because they looked cool with some promise of X% increase in HP
>and
>> or spark. Personally, I have found them to be a royal pain in the ass!!
>
>
>
>
>
|