Clutch master bummer

["James Pickard" <geowiz@worldnet.att.net>]

I rebuilt the clutch master cylinder with a kit I obtained from Sunbeam
Specialties, but it didn't work.  The new seal is smaller in diameter than
the old one, and it fits loosely inside the cylinder, hence the problem.  I
suspect the PO rebuilt the master, honing it and using an oversized seal. 
Is this reasonable?  Anybody have a similar experience?  Any chance I just
got the wrong kit?  I guess I'm down to replacing the master as my only
reasonable option.

Jim Pickard
B9473298