> I want to install a water temperature gauge where the clock would
> normally be. That opening is 2.375". The standard size gauges
> that I have looked at so far are 2.0625 and 2.625. Since I dont
> want to cut the dash and I cant find the matching size then I have
> been thinking of making some sort of hole diameter reducer. Has any
> one gone through this process? Any suggestions would be graciously
> welcomed.
>
Larry, I have installed the smaller-size oil temperature gauge in the
clock hole of both our Tigers. I used the chrome bezel from the
clock-hole plug, and a couple of layers of duct tape on the gauge
housing to make up the diference.
Ramon
|