Re: Dana shim stack up

[Frank Marrone <marrone@wco.com>]

At 02:18 AM 7/31/97 -0400, you wrote:
>Frank,
>The order is: From axle flange; Thin shims, (Hub bearing shims, split
>equeally to both sides of axle), Backing plate, Thick Shim, (Hub bearing
>retainer plate), Seal w/retainer. Don't forget the gaskets between the shims,
>backing plate, thick shim and retaianer.
>
>Gary Cooper,     Tiger Mk.II

Thanks Gary,

I take it then, that both axles need to be installed to check end play?

What do people use in lieu of the "paper" gaskets?  Silicon? 

I count a minimum of 4 gaskets required per end assuming at least one shim,
is this correct?

 
Frank Marrone          MK I Tiger B9471116
marrone@wco.com        1966 LTD  
                       '79 Spitfire
                       Yamaha Seca 900 (aka XJ900RK)