Joe,
A little tech tip on the crash pad installation. Drill from the top
1/16 or slightly larger holes in the second layer of sheet metal under where
the snap studs for the toneau are located. That way after the crash pad is
glued down you can go from the underside up through the crash pad with an
ice pick or whatever and know exactly where to install the snap studs.
Otherwise it becomes very difficult to locate the original holes on the top
and the second layer of metal blocks your view from the bottom.
Dave McDermott
At 07:31 AM 7/18/97 -0400, joe brackin wrote:
>I'm getting ready to install the new dashpad and reinstall the
>windscreen glass and frame. I've seen one note about scraping the foam
>off the new dashpad at the locations where the frame bolts go thru. Is
>this required? Any other hints about installing the dashpad would help.
>Also a while back there were notes about proper alignment of the
>windscreen. Does anybody have any advice on alignment of the frame.
>And finally is it better to install the glass with the frame on or off
>the car since I can choose at this point.
>
>
|