.int tigers@autox.team.net
When I purchased my Tiger, the PO had a chrome roll bar installed which
attached in 3 places in the back seat area. They had bolted on each side
on the edge of the back seat, a kind of hinge affair where the roll bar
was attached by running a bolt through 2 holes. The 3rd point was a
receiver bolted on the hump in the middle of the back seat which secured
the 3rd point of the roll bar with a pin.
It was kind of a cool set up because it fit under both the hardtop and
softtop and, if you pulled the pin on the middle point, put the seats
forward, you could push the roll bar forward laying it against the backs
of the seats and be able to snap the tonneau down.
I didnt care for it, as I am restoring the car to as original as
financially possible, so I took it out and welded up the bolt holes.
I still have it if anyone is interested in it. It's just taking up
space in the garage attic.
Its probably some obscure LAT option...;-)
Steve
B9470636
|