On 22 Jul 1996, Jay Laifman wrote regarding window channel installation:
> ...I put it in and
> it was too tight for my window. In fact, I ended up pulling the window
> out of the 30 year old lower channel glue/rubber. Does anyone have any
> suggestions on how to do this right?
I had the same problem with mine. I tried widening the channel
slightly with minimal success, then I was told that the secret
was to only install it from the top of the channel to about
half way down. I redid mine that way and the windows were then
quite a bit easier to roll up/down (still not perfect, though!)
............................................................
Kevin Meek (kevnmeek@netcom.com) Sunbeam Tiger B382002202
Santa Cruz, California Sunbeam Alpine SI B9011324
|