In a message dated 12/18/2005 7:26:06 PM Eastern Standard Time,
soavero@yahoo.com writes:
Thinking about adding an EGT gauge to the race Sprite header. Question is,
what temp range should I be looking to achieve? Engine is a 11.5:1 1275.
I, of the melted piston...what do I know...but when I put mine in, the advice
was 1350 is about as hot as you want to see. Now, what I know for sure is
you want to put the gauge where it is in your field of vision. Not down in the
console, where mine is.
Also, I have never regretted buying the dual gauge and putting a thermocouple
in the both the front and the rear header pipes. A bit more specific on
whether one carb is more lean/rich than the other.
JohnD
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/team-thicko
|