Haven't read the article yet, but general rule of thumb is 1 to 1.5 degrees
for bias ply, and 3 + degrees for radials.
-----Original Message-----
From: owner-team-thicko@autox.team.net
[mailto:owner-team-thicko@autox.team.net]On Behalf Of Ron Soave
Sent: Thursday, July 03, 2003 8:49 PM
To: team-thicko@autox.team.net
Subject: BFG R1 article
http://www.porschenet.com/bfgtires.html
I would be interested to know what those of you who
have/are running these have done for camber on a
Sprite, as the article implies that the offset tread
design mitigates the need for high negative camber.
Also, the recommended cold pressures are higher than
people were running at BHF - Elmo mentioned spinning
at pressures at or about the recommended pressures.
'hopper
__
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/team-thicko
|