Ok all you performance gals and guys..
heres questions i am sure has been beat to death at sometime or another..
should i install hardened/SS, or such valve seats in my "racing" (lol) head
in tinkerbell?
since i am freshining it up, i noticed i AM getting recession in the head.
So we are considering the seats. 5 angle grind of course.. any suggestions?,
experience, good/bad? seats cracking?, falling out? best mod ever?..
the head isnt anything magic though i did some backyard porting/smoothing
myself and its at least not any worse.
heres another question dear speed folks..
whats the word on aluminum spring retainers? i found a cracked spring and am
going to replace the lot. should i replace the old steel discs with fancy
tops too? any suggested spring pressure with new hardened seats if i install
them? i think 320# is about right, any comments? i am going to put in the
higher ratio rockers too..
just looking for second opinions above my own.
R Kansa southwind racing
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/team-thicko
|