Gerard
We run them in tinkerbell. intresting setup, these are the "short" pistons,
wich refers to the pin hieght. we use modified stock rods that accept a fully
floating pin. we run teflon side buttons. we also have decked the block to help
achieve the c.r. They seem to work reasonably well. they were a bit of a hassle
to get right...but seem to be worth it.
R(wnik) Kansa
Anybody here have any knowledge of Cosworth pistons? I have a set for the
948 race engine I'm putting back together and would like to find out more
about them.
Thanks
Gerard
--
Please visit Four Points Travel -
Discount Online Hotel Reservations in the U.S.
http://www.gerardsgarage.com/fourpoints
To make a reservation please call Toll Free 1-800-272-3253
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
|