I'm inclined to use alloy sheet. I use the original as a pattern, cut to size,
tape the edges, cover with a thin foam backing, then use the original vinyl. I
haven't done this on the back side of a Sprite, but on many other British cars.
Tom
> On February 5, 2020 at 8:33 AM JMFangio via Spridgets
> <spridgets@autox.team.net> wrote:
>
>
> Good Morning all,
>
> so I took a look at the inside of the boot and the cardboard panels that were
> so nice when installed many years ago have slumped and look terrible. I was
> wondering if any of you fine folk had or had considered using fiberglass
> resin to reinforce them?
>
> My thought is to get them flat-ish and paint the backside with resin.
>
> What say you all?
>
> Lester
>
> ------------------------
>
> spridgets@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Suggested annual donation: $12.75
>
> Archive: http://www.team.net/pipermail/spridgets
> http://autox.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/spridgets/tomspringer@comcast.net
------------------------
spridgets@autox.team.net
Archive: http://www.team.net/pipermail/spridgets http://autox.team.net/archive
|