Kirk,
Master or slave cylinder?
If the slave cylinder is not leaking then it is probably good.
Maybe the master cylinder is not pushing quite far enough to fully
disengage the clutch. I've had this happen a few times.
Kevin V.
Tuscarora, Pa
On Jan 22, 2012, at 7:31 PM, Kirk Hargreaves wrote:
> I had clutch pressure. . but it would not shift
> into gear.
>
> Could it be that the gear box was at fault. . or? A strange
> situation
> for me as I had expected to once again find a thrashed T bearing as
> the
> culprit.
------------------------
spridgets@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation: $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|