Unless you are going to use them with thick metal, greater 1/8 inch non- Al,
you can just use a screw and washers to pull them in place. I used a couple of
these from electronic chassis parts on the back of the BE to hold the rear
license plate
Sent from my iPhone
On Dec 3, 2011, at 3:52 PM, Billy Zoom <billyzoom at billyzoom.com> wrote:
>> HF has one. I've made one from a hand riveter and used the HF unit, too.
> Yeah, but the video was for the $2500 electric tool. The pneumatic guns are
> a little less, but still well over a grand. The HF model is pretty useless
> for steel rivnuts. There are some big manual tools for around $700 that work
> OK, but they still hurt if you have to do a bunch. It seems like $2000 is
> the bottom line for anything that'll install them on a regular basis. I
> never find them used either.
> BZ
> _______________________________________________
>
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/spridgets/bkitterer
> at mac.com
|