That sure would take a lot of the fun out of working on the spridget,
especially if you had help emptying the cooler....
Dave
At 09:29 PM 8/1/2011, you wrote:
>No libating while working on Spridget; both of you may suffer.
>Celebrate the end of each day away from the Sprite. ...bill in corvallis
>==================================================
>-----Original Message-----
>From: Andrew Payne [mailto:andrewpayne@intrex.net]
>Sent: Monday, August 01, 2011 6:24 PM
>To: corvallis@peoplepc.com; spridgets-bounces@autox.team.net; Spridgets
>Subject: Re: [Spridgets] Working on the car, this time for real!
>
>After much investigation, and ingest-libation I have determined that I will
>proceed. My two questions at this point are these:
>Where should I put the stands once I remove the rear suspension?
>Many of the vertical panels have rust only at the very bottom-think wet
>carpet dimensions-so the tabs are unusable. Should I use some angle steel
>sections, or is there a better route?
>Drew
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|