Bob,
I don't know if you remember, but there is a page on my web site of
data you put together years ago.
http://gerardsgarage.com/Garage/Tech/SpridgetSpecsWS.htm
You'll see that you are credited as the source.
Gerard
http://gerardsgarage.com/
On Jul 20, 2011, at 11:00 AM, spridgets-request at autox.team.net wrote:
> Message: 1
> Date: Tue, 19 Jul 2011 14:25:02 -0400
> From: Bob Spruck <mgmaven at bellsouth.net>
> To: Bill L <pythias at pacifier.com>
> Cc: spridgets at autox.team.net
> Subject: Re: [Spridgets] Brakes 66 Sprite
> Message-ID: <20110719182519.A60FD18764D at autox.team.net>
> Content-Type: text/plain; charset="us-ascii"
>
> The rods used for the hand brake are different on the steel wheel
> rear than on the wire wheel rear. The info below is copied from my
> Sprite Specs Document that will someday make it to a web site I plan
> to create.
>
> I removed the entire hand brake assembly when I installed the Panhard
> bar on my 67 steel wheel vintage race Midget. I have the complete set
> of parts. I also have 7 parts cars both wire and steel wheel, so if
> you need the parts, let me know.
>
> Bob Spruck
>
>
> REAR AXLE ASSEMBLY
> DIMENSION
> MEASUREMENT POINTS
>
> STEEL WHEEL DIFF ASSY
> Over all width* 41 3/4"
> (41.75") From inside of brake backing plate flange to
> inside of opposite flange
> Left Hand Brake rod 14 3/4" (14.75") From
> center to center of clevis pin holes
> Right Hand Brake Rod 26 1/4" (26.25") From center
> to center of clevis pin holes
>
> WIRE WHEEL DIFF ASSY
> Over all width* 40 3/4" (40.75") From
> inside of brake backing plate flange to inside of opposite flange
> Left Hand Brake rod 14 " (14.00") From
> center to center of clevis pin holes
> Right Hand Brake Rod 26 " (26.00") From
> center to center of clevis pin holes
>
> *Wire wheel assembly is 1" narrower than steel wheel assy
> *Wire wheel and steel wheel rear hubs are same except for
> stud length
|