For now I suggest take your pane of glass to a local window/glass shop. They
can take 1/4 inch off of it for a couple of bucks or a 6 pack. Meanwhile,
cut 1/4" off the 45 degree mitre on each side. A Dremel with a cut-off disk
will do this cleanly.
Failing that, get a 16" x 20" frame and a sheet of 16" x 20" matte from
Hobby Lobby or similar place. You cut the matte on a bias with an Exacto
knife and a steel straight edge. You can cut it to exactly fit the poster
you have. Most Hobby type stores would cut the matte for you with a
professional matte cutter for a little bit of nothing.
FYI... My bad! I was not aware of this dimension problem with the poster.
Now that Ryan has identified the problem I have taken down the poster from
the Sprite-MidgetClub store temporarily. The artist is going to resize the
poster. When that is done, It will go back up on the store. The small size
will be a correct 16"x20" and the large poster size will be 23" x 35". I
will post to the list when these are ready and available. Probably a couple
of months given the artist's workload and the fact that it is being done pro
bono.
Hope this helps....
Cheers!!
Jim
On Wed, Mar 3, 2010 at 3:47 PM, David Ambrose <stargazer1@cox.net> wrote:
> On 3/3/2010 1:20 PM, Rick Fisk wrote:
>
>> Even with a brandy-new glass cutter 1/4 inch is next to impossible to
>> remove.
>>
> I've done this a few times. Score the glass deeply, then use the notches in
> the glass cutter to engage the glass and break it on the score. It helps a
> lot of the notches are a tight fit over the glass.
>
> Cheers,
> Dave
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Suggested annual donation $12.75
>
> You are subscribed as bmwwxman@gmail.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
>
--
Cheers!!
Jim
In my many years I have come to a conclusion that one useless man is a
shame, two is a law firm, and three or more is a congress."
John Adams
US diplomat & politician (1735 - 1826)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|