Drill a 1/4" hole in one end, where it will be hidden once you re-attatch
the seal. Tip up and empty all of the rivet pieces out through the hole.
Dave Riker
----- Original Message -----
From: "Richard Ball" <richb@u.washington.edu>
To: <spridgets@autox.team.net>
Sent: Wednesday, February 17, 2010 12:20 PM
Subject: [Spridgets] Top/Header Rail question
> I was planning to drill out the rivets, but I don't see a way to get the
> remains out of the header rail after they a drilled out and drop into the
> space in the header rail? Am I missing something, or are they just left
> in
> there to rattle around?
>
> Rich Ball
> '76 Midget
> Everett, WA
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Suggested annual donation $12.75
>
> You are subscribed as davriker@nwi.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.733 / Virus Database: 271.1.1/2693 - Release Date: 02/16/10
23:35:00
[demime found a multipart/alternative section which it tried
to parse but could not find any section which it could render. Please send
plain text.]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|