I have been living with the bad aftermarket synchros that Paul A used (he
sent me a correct set to replace them) during the rebuild of my Datsun
tranny since I installed it a couple of years ago. It just kinda crunches
going into 3rd gear if the main shaft is still turning to fast. I cannot
downshift very well either, so I have just been careful driving it until I
can pull it out for another rebuild. Well, I am almost getting to that
point now, but another problem has shown up. It pops out of 3rd gear under
hard acceleration or if I touch the gear shift in a backward movement. Just
a slight touch will do it. What causes that. Just trying to find out what
else to look for when I take this thing down.
Mike MacLean
60 Sprite
56 BN2
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|