Handbrake? How many clicks to lock the rear brakes?
Should be 3 or 4.
If more adjust the rear shoes.
Peter C
==
At 07:33 PM 12/31/2009, you wrote:
>59 Bugeye with front disks.
>
>3/4 inch original master cyl that came with the parts for converting to disk
>brakes.
>
>System *completely bled*. . including slave cyl.
>
>Now, no leaks. .
>
>New cap on master cyl. with cork gasket.
>
>I still have to pump up the brakes to get pressure to stop - brake pedal
>will not hold on a hill. Clutch works fine.
>
>I have exhausted everything I can think of.
>
>When I push the rod into the master cyl I notice the fluid pushing hard to
>the bottom of the cap. (Translucent white cap). This might point to a block
>in the system? However, my Gunson bleeder seems to push good pressure
>through the system when I bleed the brakes.
>
>
>Master Cyl had a rebuild kit installed about two years ago. And again, the
>clutch is holding pressure.
>
>If there was a leak in my master cyl brake bore - I would also see fluid
>coming out of the front of the cylinder (like with my slave cyl when it was
>leaking)?
>
>*Any help at all is very much appreciated. . *
>
>
>Thanks!
>
>
>
>Kirk Hargreaves
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>You are subscribed as peter@nosimport.com
>
>http://www.team.net/archive
>
>http://autox.team.net/mailman/listinfo/spridgets
>
>
>No virus found in this incoming message.
>Checked by AVG - www.avg.com
>Version: 9.0.725 / Virus Database: 270.14.123/2595 - Release Date:
>12/31/09 02:52:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|