vacuum comes off of the base of the Weber...
To: Richard Ball <richb@u.washington.edu>
Cc: spridgets@autox.team.net
Sent: Wed, October 14, 2009 3:07:54 PM
Subject: Re: [Spridgets] still no workie...
Richard Ball wrote:
>
> Here are the symptoms again. The engine starts right up and idles fine.
> When you open the throttle the engine RPM increases as it should until about
> 2200 RPM. At this point any further opening of the throttle causes the
> engine flatten out, bog down, stumble,
Are you pulling a vacuum off the intake for the vac advance?
Not a good idea.
Not being familiar with the guts of this dizzy, but is the advance plate secure
or is it floating around.
I just found this problem out on some one else's Sprite he loaned me. Talk
about variable timing!
-- Frank Clarici
Toms River, NJ
My own Fleet of Sprites
You are subscribed as eap2140@yahoo.com
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|