Piece of cake, just pull engine and tranny, then tear the tranny
apart and tighten the nut at the end of the main shaft, the gear is
slipping on the main shaft. It's a dumb setup with a pinched gear to
drive the pinion gear. Reassemble in reverse order. Should take a day
or two to accomplish, three days if you decide to detail the engine
bay while the engine and tranny are out.
Dave
At 10:52 PM 5/14/2009, you wrote:
>I'm working down my list...
>
>Well, I know my speedometer works down through the cable that reaches the
>transmission (rib case) via cordless drill...
>
>Upon disassembly, I find that the plastic gear slips on the metal shaft.
>Any way to refresh this?
>
>Chris
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|