The TO bearing is supposed to be in constant contact with the pressure
plate. Like the pads on disc brakes, there is no spring to pull the throw
out bearing away. It is the diaphram spring itself returning to rest that
pushes back on the TO bearing. If the bolts holding the pressure plate to
the flywheel were tightened out of sequence or incorrectly, the surface that
the TO bearing rides against may not be spinning flat. A bent throw out
fork could also cause a rattle when not under pressure if the TO is not
centered to the pressure plate. Worn release arm pivot points could too.
David R.
----- Original Message -----
From: "Marc" <smarc@smarc.net>
To: "Spridgets" <spridgets@autox.team.net>
Sent: Saturday, May 02, 2009 2:53 PM
Subject: Re: [Spridgets] 1275 pressure plate question
> OK, I put the car up in the air, and peeking through the inspection
> port, I can see that the TO bearing is touching the hub of the
> diaphragm. It don't think theres much pressure on it, but perhaps ANY
> is too much? Should there be a gap there? If so, how much?
>
> I don't want to blindly start hacking away at the push rod...
>
>
> Ron Soave wrote:
>> Spot on Marc - It should not (it's busted) and is caused by too much
>> travel,
>> typically. I know from experience....
>>
>> --- On Sat, 5/2/09, Marc <smarc@smarc.net> wrote:
>>
>> From: Marc <smarc@smarc.net>
>> Subject: [Spridgets] 1275 pressure plate question
>> To: "Spridgets" <spridgets@autox.team.net>
>> Date: Saturday, May 2, 2009, 8:20 AM
>>
>> Good Morning!
>>
>> I got motivated to see what was making all that rattling racket from the
>> transmission. The noise silences with just the slightest pressure on the
>> clutch pedal So I pulled the motor and found that the hub in the center
>> of the
>> diaphragm springs (where the throwout bearing presses on) was loose and
>> could
>> rattle around. I made the brash assumption that this was the cause of the
>> noise...
>>
>> Can someone confirm that this hub should NOT be loose like that?
>>
>> Seems like it could have been damaged by perhaps too much pushrod travel
>> ?
>>
>> --
>>
>>
>
> --
>
> Marc
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as davriker@nwi.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.238 / Virus Database: 270.12.15/2093 - Release Date: 05/02/09
14:23:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|