What? Frank hates U-Joints!?
Why, it's easy. (if you're very lucky) As several others have pointed
out, John Twist can do it in five minutes!
You can't let a Midwesterner get the better of you or you'll have to
start eating deep dish pizza. :)
http://www.youtube.com/watch?v=gDX17xf9grA&feature=PlayList&p=CFB510794339861C&playnext=1&playnext_from=PL&index=11
Date: Sun, 29 Mar 2009 22:16:43 -0400
From: Frank <spritenut@comcast.net>
Subject: [Spridgets] I hate U joints
To: Spridgets <spridgets@autox.team.net>
Message-ID: <49D02B8B.7010108@comcast.net>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
Ever since I was 18 and owned a shitfire that needed U joints once a
week, I hated them
I hate replacing U joints so much that I am forever using good used
driveshafts in any Sprite I restore.
Well I am out of good used shafts BUT I had a pair of U joints and a few
driveshafts to beat apart.
So why is it EVERY FREAKING time a needle bearing drops and screws up my
new U joint?
I have tried several different methods of pressing them in, beating them
in, dropping the knuckle into the cap and every single time I mess up at
least one cap by dropping a needle bearing.
Tonight was no exception, 2 new joints, 2 now with one cut needle each.
(quality Japanese steel)
Yes made in Japan on the box. Imagine chinese U joints? I can't.
From now on I will just take the drive shafts to the machine shop, it
just not worth the aggravation.
You would think someone would come up with a better U joint. No needle
bearings or at least have them retained somehow.
-- Frank Clarici Toms River, NJ My own Fleet of Sprites
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|