Hal,
Use soft, modeling clay on top of highest part of engine.
Start with small piece, increase until it shows signs of contact.
Herb
On Wed, Mar 25, 2009 at 7:56 PM, Hal Faulkner <frog.aye@gmail.com> wrote:
> Does anybody know how to figure under bonnet clearance on a FROG AYE? I am
> trying to decide if I can build a cold air box for FROG AYE, but have no
> Idea how much clearance I have. I am using 3" K&N filters (6" dia) and the
> edge of the filters is just about 1/4" higher than the top of the oil
> filler
> cap. Any techniques for figuring how much room I have to play with will be
> greatly appreciated.
> Hal
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|