I would like some as well! I can get hood to A pillar gaps even and
maybe even hood to cowl gap good BUT then the alignment pins up front
will NOT go into the alignment holes.. and I followed Frank's advice
and took the hood gasket out so that the hood is now level with the
cowl..
Thanks,
Lester
On Feb 10, 2009, at 3:22 PM, Mark Haynes wrote:
> I finally got around to trying to slide the BE bonnet into its correct
> position relative to the scuttle this weekend (there's about 1/2" of
> opening).
> I was able to get the bonnet to move towards the scuttle on the
> hinges, but
> the gap hasn't decreased significantly. There is movement within the
> passengers side hinge assembly, I think the welds may be broken
> loose in the
> support structure. Any other ideas/experiences that might explain
> why it sits
> so far forward? Could the hinge bolts themselves be bent or worn
> this badly?
>
>
> Mark Haynes
> HAN6L12779
> HAN5L8016
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|