Trust you to find something that no-one else has had!!
WELL DONE!
Guy R Day
----- Original Message -----
From: "Frank Clarici" <spritenut@comcast.net>
To: "Spridgets" <spridgets@autox.team.net>
Sent: Thursday, January 29, 2009 11:10 PM
Subject: [Spridgets] Now it starts
> And runs well.
> Turned out to be the header was keeping the bottom of the intake from
> sealing.
> In pulling it off to check to see if I pulled out all the paper towels
> keeping dirt out of the engine...
> I knew I pulled them out but did I forget one?
> Turns out, no, I didn't leave any towels in the holes. But Brian noticed
> that there was a paint mark on one hole of the gasket but not the other.
> Turns out the intake was rocking on the center header pipe, not so much
> the intake but the heat shield.
> Some strategic blows with a BFH fixed it right up. It ran long enough to
> set the carbs, now it runs well.
> I knew it was acting like a major intake leak but the nuts were tight,
> the manifold was not damaged, who would have thunk it?
>
> --
> Frank Clarici
> Toms River, NJ
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as grday@btinternet.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|