Phill. Measure up from the floor to the center of the lights. then a peice
of tape on the inside of the garage door the same height. Tape on the door
straight out from the head lights as well. Line up the car and adjust your
lights.
----- Original Message -----
From: "Phil Nase" <nases@verizon.net>
To: "spridgets Spridgets@autox.team. Net" <spridgets@autox.team.net>
Sent: Wednesday, November 26, 2008 5:59 PM
Subject: [Spridgets] aiming headlights
> Any rules of thumb for aiming headlights to get them at least close to
> correct before I take it out for a nighttime spin?
>
> Also, the bugeye bonnet lock handle is held in place by putting a
> screw in the end and spreading the shaft? Or is there a pin or
> something to use?
>
> Phil Nase
> Quakertown, PA
> http://home.comcast.net/~philnasecpa/
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as jlaird237@cox.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.175 / Virus Database: 270.9.10/1813 - Release Date: 11/26/2008
8:53 AM
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|