Guys,
I have two rear wheel hubs that I have cleaned up for installation. Both
have the same part number (2A7088) but one has a thinner "flange" than the
other. All of the other dimensions are the same. Question: Is there any
difference in application or is the thinner one really any weaker than the
thick one? Maybe I should put the thick one on the right side? A picture
of what I am seeing is at the following link:
http://www.nashvilletn.org/Bugeye/hubs.jpg
Mark
Nashville
http://www.arrestmered.com
58 "Bugeye"
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|
