Alright, already. It's arcing. It occurs when the wire is removed from the
plug, but only on cylinder 1, from the distributor end to ground, not plug
end to ground. The plug is fine. What condition not related to a bad
distributor cap can cause grounding when there is no plug? For example, I
think the (used) coil may be higher voltage than stock, and the stock
insulation may be inadequate for pin 1, which is relatively close to the cap
holder gadget.
Michael Rowe
'74 Midget
Long Island, NY
I would guess that this
> means that there is too much resistance at the plug for some reason.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|