Thanks, Kevin.
I appreciate your help.
Norm
-----Original Message-----
From: K. Valentine [mailto:kevin@valentinephoto.net]
Sent: Tuesday, March 04, 2008 9:31 PM
To: twobees@sprynet.com
Subject: Re: [Spridgets] Sway Bar
On Mar 4, 2008, at 8:46 PM, Norm 2Bs wrote:
Anyone have a Spridget bar handy you can measure?
Norm,
Answers below;
The Turner's has the following dimensions:
Total spread of 30".
Spridget - 30"
Main straight of c. 24"
Straight section is closes to 23"
Each side arm is c. 4"
4" not including the flat portion where the link attaches.
Bend from front to sides is approx. 62-degrees, leaving c. 28-degrees from
sides to mounting flange.
Very close.
Approx 5" front to back - front of middle section of bar to centerline of
hole in flange for link bolt.
Same
Your help will be appreciated. Thank you.
You're welcome.
Kevin
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|