--===============1120649536==
Content-Type: text/plain; charset="windows-1250"
Content-Transfer-Encoding: 7bit
Frank,
I am not sure of the measurements, but jacking the
car up so that the front wheels hang down does
cause them to toe-in. If you think about the fixed
height of the steering rack, the ideal is that the
two track rods are horizontal with the rack. When
you raise the front of the car thetie rods point
downwards so the outer ends don't extend as far
from the centre line of the car. If they hung down
at an angle of 45 degrees you can visualise how
much the ends would come in from their level
position. They won't be as bad as that, but you
can get the idea.
Toe-in has to be set with the car standing firm on
level ground.
Wern't the early and late racks of different
lengths and used different tie rods? Maybe you
have gotr mis-matched tie rods with your rack?
Guy
-----Original Message-----
From:
spridgets-bounces+guy.weller=tiscali.co.uk@autox.t
eam.net
[mailto:spridgets-bounces+guy.weller=tiscali.co.uk
@autox.team.net]On
Behalf Of Frank Clarici
Sent: 21 February 2008 00:59
To: Spridgets
Subject: [Spridgets] Front end gurus
67 Sprite, everything new and no bent frame.
Steering rack is centered and the tie rod ends are
screwed on 15 full
turns each which has always worked for me for
getting the toe in dead on
or damn close.
So tonight I checked the toe in, it is 1.75"
(1-3/4") toed OUT
when sitting on the floor. Ah, could be 1/2 the
camber problem, but when
I jack up the car and recheck the toe in, it's off
(out) by 3/8".
Or 1/2" out of whack if I were to set it 1/8 toed
in.
So does jacking up the front of a Spridget change
the front end geometry
by an inch and a half?
Both wheels are tight, new bearings and I checked
them after a drive and
could not get them any tighter. So it's not the
bearings, nor the hubs.
It's a bit too cold to be laying on the concrete
floor tonight so I'll
go mess with sticking small speedometer guts in a
large housing and
stick some heat shrink tubing over the high beam
indicator tube so the
dash illumination stops making me think the high
beams are on.
Yeah, that little plastic or rubber sleeve that
disintegrates with age
is an easy fix with a short piece of heat shrink.
--
Frank Clarici
Toms River, NJ
You are subscribed as guy.weller@tiscali.co.uk
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
Version: 7.5.516 / Virus Database: 269.20.8/1288 -
Release Date: 19/02/2008 20:47
--===============1120649536==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
--===============1120649536==--
|