Uh... this would be the Bugeye? With what carbs?
H1 carbs I recommend bushing the bodies and using standard
shafts. HS2 and beyond can use oversize.
Standard size for both shafts is .248" Oversize is +.010" I
STRONGLY recommend using a reamer.
Why not use oversize on an H1 you ask?
Because then you have to oversize the throttle linkage stuff....
Peter C
Vern.... Again, this is NOT the 79 Midget mentioned in your
signature, is it? LOL
=========================
At 08:22 AM 11/30/2007, vern@srvinet.com wrote:
>In cleaning up my carburetors I see that the rear has
>a little slop in the throttle shaft. The suppliers show
>oversize shafts. Can anyone tell me what size hole
>the bigger shaft takes and is it safe to use a twist drill
>or should I look for a reamer. Probably need a set anyway, but
>need all my available cash for parts, Priorities, priorities.
>Vern
>
>--
>See my 79 midget RB at:
>
>http://olsen.ispeedwireless.net/
>_______________________________________________
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|