spridgets
[Top] [All Lists]

[Spridgets] fulcrum pin threads

To: spridgets@autox.team.net
Subject: [Spridgets] fulcrum pin threads
From: "Mark A. O'Neil" <mark.a.oneil@Dartmouth.EDU>
Date: Sun, 4 Nov 2007 11:59:12 -0500
Okay so before I totally screw something up...I need to know if there  
is a problem here or if I am just not being forceful enough.

I thread the fulcrum pin into the a-arm and the small end threads  
bite and thread for about 1/16 an inch or so - seemingly until the  
large end starts to bite then I can no longer turn the pin. I can  
flip the pin and thread it clear through the large end so I know  
those threads are clear. All this by hand with no tools.

When I did the other side I recall it being a bit of a pain to thread  
the pin all the way in, but I chalked that up to inexperience and  
some corrosion.

I am off to see if I can get a bolt that matches the smaller end so  
that I can chase those threads.

This is a rebuilt arm.

thanks,
-m
_______________________________________________

Edit your replies

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>