Unfortunately, can't do it that way in a Spridget rear end!
Paul A
----- Original Message -----
From: "Bob Spruck" <mgmaven@bellsouth.net>
To: "Jerry Goodman" <jerry.goodman@comcast.net>; <Spridgets@autox.team.net>
Sent: Thursday, October 18, 2007 5:51 PM
Subject: Re: [Spridgets] strange problem expert needed
> While vintage racing at Daytona a few years ago, a buddy broke an axle. It
> was bent and shattered at the splined end in the diff. Couldn't get it out
> from the flanged end. We pulled the other axle and inserted a long 1" dia
> piece of pipe that was in contact with the opposite (broken) spline and
> pounded like hell while turning the broken axle. It eventually pushed the
> broken axle out.
>
>
>
>
>
> At 03:01 PM 10/18/2007 -0500, Jerry Goodman wrote:
> >I have a broken halfshaft on the bugeye. The problem is I cannot pull it
> >out....It comes out about 3/8 inch and binds up. I have tryed prying
> >it..hammering it ...took out other halfshaft...slid right out. Unbolted
> >differential...but cannot remove because halfshaft stilll engaged. If I
turn
> >halfshaft differential turns ....but in some positions it does not spin
diffy
> >so I feel certain it is a half shaft problem. Open to any ideas
> >Thank you in advance
> >Jerry
> >_______________________________________________
> >mgmaven@bellsouth.net
> >
> >Edit your replies
> >
> >http://www.team.net/archive
> >
> >http://autox.team.net/mailman/listinfo/spridgets
> >
> >
> >--
> >No virus found in this incoming message.
> >Version: 7.5.488 / Virus Database: 269.15.0/1077 - Release Date:
10/18/2007
> >9:54 AM
>
> Bob Spruck
> MGMaven
> Sharpsburg, GA
> 67 Midget Vintage Racer
> 72 Midget Street and Show
> 6 parts/project cars
> _______________________________________________
> pasgeirsson@worldnet.att.net
>
> Edit your replies
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|