If you check the K&S metals rack at the local hardware or hobby shop, you'll
usually find a small plastic pack of "shim"material". Various thicknesses
of brass about 4"x6". Easy to use scissors to cut out shim washers of
whatever thickness you want to try.
Glen
Subject: Re: [Spridgets] Tapered roller bearings
> Derf:
> Thanks. I think if it were A-arm bushings, it would not go away when I
> tighten up the bearing. One "castle" is really quite a lot in
> thousandths of an inch, I believe. Although I'm no machinist, so numbers
> like that don't translate very well into "feel" for me.
> The fine adjustment is done with shims but I don't know where to get
> them or where to put them.
> JohnD
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|