Call me a bit daft, But wouldn't it be the same as the I.D. of the
aforementioned bearing?
-----Original Message-----
From: spridgets-bounces+pelliott=innercite.com@autox.team.net
[mailto:spridgets-bounces+pelliott=innercite.com@autox.team.net] On Behalf
Of Daniel1312@aol.com
Sent: Wednesday, September 05, 2007 2:05 PM
To: spridgets@autox.team.net
Subject: [Spridgets] Crankshaft Spigot bearing removal
Hi List,
I've discovered that my engine has had a new spigot bearing fitted to it.
Unfortunately I need to remove it as my car runs a Ford based 5 speed
conversion
which uses a spigot adaptor.
I recall the recommended technique is to fill the end of the crank with
grease and hydraulic the spigot out by the use a drift or old gearbox input
shaft.
I don''t have an old gearbox or input shaft to use let alone measure any
more
than I have a drift of the right size. I don't mind buying a drift of the
right size but need to know the size.
So, anyone have the size?
Thanks
Daniel1312
_______________________________________________
pelliott@innercite.com
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|