spridgets
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [Spridgets] valve guides

from [Hal Faulkner] [Permanent Link][Original]
To: "WJHS1960" <WJHS1960@comcast.net>, "Spridgets" <spridgets@autox.team.net>
Subject: Re: [Spridgets] valve guides
From: "Hal Faulkner" <hal@katemuir.com>
Date: Sat, 25 Aug 2007 11:08:12 -0700 
Missed the post that this is a response to, but....
The tap that I used to chase the threads on the air holes on my 12G1316 head
is clearly marked 1/8-27 NPT.  Much bigger in diameter than 1/8".

Hal

-----Original Message-----
From: spridgets-bounces+hal=katemuir.com@autox.team.net
[mailto:spridgets-bounces+hal=katemuir.com@autox.team.net]On Behalf Of
WJHS1960
Sent: Friday, August 24, 2007 3:04 PM
To: Spridgets
Subject: Re: [Spridgets] valve guides


<<not 1/8-27 pipe thread...>>

Yep.  1/8 would just fall inside<G>!!
_______________________________________________

Edit your replies

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [Spridgets] it's only fair (book recommendation), Robert Bruce Evans
Next by Date:  Re: [Spridgets] valve guides, Hal Faulkner
Previous by Thread:  Re: [Spridgets] valve guides, WJHS1960
Next by Thread:  Re: [Spridgets] valve guides, Hal Faulkner
Indexes:  [Date] [Thread] [Top] [All Lists]