When replacing the center main, wheather it be a 2
or 4 bolt, you will have to have the mains align bored
and the trust washer area also trued up and because
the new center main is VERY hard material your
machinist will have some choice words for you.
--- Daniel1312@aol.com wrote:
> Hal,
>
> The centre main has a harder life than the end
> bearings so generally it's
> only the centre main that gets the reinforcing
> strap. I have however, seen a
> photo of an A-series engine with all 3 bearing caps
> strapped.
>
____________________________________________________________________________________
Be a better Globetrotter. Get better travel answers from someone who knows.
Yahoo! Answers - Check it out.
http://answers.yahoo.com/dir/?link=list&sid=396545469
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|