The cam sprocket bolts on my XK motors were drilled and wired for
safety reasons. A pain to wire in but the alternative doesn't bear
thinking about.
The picture shows exactly how the holes should be drilled.
But you need to use a cutting oil to enable drilling at an angle.
Dave G.
> > I have had a tool like this for drilling safety wire holes in nuts
> and the heads of bolts. I have never been able to use it
> successfully, always breaking the drill or dulling it to uselessness as it
> abrades against the angled flat.
> >
> > http://tinyurl.com/3y83tx
|