Hi.
I doubt if anything is bent, since it was working ok. Assuming you have the
correct diameter master and slave the travel should be adequate. So there could
still be air in the line. Or there could be worn parts.
Or a combination of the two.
Good luck.
J
-------------- Original message --------------
From: Robert Weeks <lists@woozy.com>
> Hi John,
>
> Swapped both the slave and master. Before I did the swap the slave was
> rusted and wouldn't move. 5 years ago when the car was parked it worked
> fine.
>
> Robert Weeks
> Bahama, NC
|