Eric did original Bugeye A-arms (no holes for a roll bar) back in 2000.
Did a great job back then.
Mike MacLean
60 Sprite
56 BN2
derf
> My A-arms arrived back from the rebuilder. He seems to have done a
> fine job. The only thing out of the ordinary was a note stating that
> I would need to shorten the small side of the pin because of the
> design of the new trunnions. Also, the side that normally is just
> plugged has a hole for a grease zerk, which I was going to add anyway,
> so that is a plus.
> If your A-arms need attention, this guy does a pretty good job for $75
> each, plus shipping:
>
> Eric Jones in
> Delaware Ohio (740) 363-2203
>
> Cheers,
> Derf
|