Nevermind, I found Frank's BFH and gave it a bloody good whacking. It
gave up. I won.
Now off to the inspection station.
Larry
On Oct 12, 2006, at 3:29 PM, Larry B. Macy, Ph.D. wrote:
> I am having an H of a time trying to replace a tie rod end. The ball
> joint is bad and it got failed for safety inspection for it. I picked
> up a ball joint splitter. (the kind you use with a hammer) but the
> frigging thing won't give.
>
> Any suggestions??
>
> Larry
>
--
Larry B. Macy, Ph.D.
macy@bbl.med.upenn.edu
System Manager/Administrator
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104
"Anyone who slaps a 'this page is best viewed with Browser X' label on
a Web page appears to be yearning for the bad old days, before the
Web, when you had very little chance of reading a document written on
another computer, another word processor, or another network."
-Tim Berners-Lee in Technology Review, July 1996
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
|