---- Joe Lansing <kidjoevid@yahoo.com> wrote:
OK - how do you re-mount the engine onto the front motor mounts?
The steering side motor mount stays bolted to the chassis. Undo the rubber
mount piece on that side so that the steel mount on the front engine plate
comes off there. On the opposite side, the whole mount is attached to the
front, free from the chassis. As you lift the engine in, line up the steering
side first and start the nuts after getting the bolts through the front plate
mount. Then shift (wiggle) it around until the opposite side motor mount lines
up with the three bolt holes. Replace the bolts, tighten everything up and,
viola!
Kent
1960 Bugeye
1975 Midget - some day auto-x-er
1973 TR-6
|