JMFarley50@aol.com wrote:
> - with one end
> going to the coil and, I assume, the other end to the key switch. Where
>does
> the other spade connector on the back hook up to?
Correct on the white wire. FROM key TO coil via tach loop.
The other spade is for a green wire (hot when key is on)
You can grab a lead from the B side (solid green) of the fuel gauge or
the green wire at the signal switch.
I would suggest a good ground too, these tachs ground through the
knurled nut on the mounting stem, not a good ground. Most tachs have a
spade on the can, run a new seperate ground from that spade.
--
Frank Clarici
Toms River, NJ
|