Trevor Boicey (sp??) an old list member did it a few years ago and
posted pics on his website. I have not seen Trevor around for a
while, but as I recall he had to use a jack to widen the tunnel a bit
to make it fit. So yes it is doable.
Just found it and it is still there
http://www.brit.ca/~tboicey/midget/midget_overdrive.html
Larry
On Jun 30, 2006, at 09:09 AM, Karl Vacek wrote:
> Is it possible to fit a J-type OD to a 1500 Midget, given that it's
> done on
> the Spitfire version of this transmission ? If so, I suppose the
> driveshaft
> would need to be shortened, but is there any frame or body cutting
> required
> ?
>
> Thanks!
> Karl Vacek
>
--
Larry B. Macy, Ph.D.
macy@bbl.med.upenn.edu
System Administrator/Manager
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 1015 Gates
Philadelphia, PA 19104
"I think the problem, to be quite honest with you, is that you've
never actually known what the question is." - Douglas Adams
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
|