You may be able to use a Locktite product to seat the bearings in the hub so
they don't slip. If not, new hubs.
Did you use spacers in assembling your radius rods? Sounds like they were
missing.
Roger
Hal Faulkner <hal@katemuir.com> wrote:
, the bearing on the left side slips in and
out of the hub, held together by the big nut with the lock washer on it. Is
this a abad thing? Am I looking at replacing rear hub[s] and bearings?
. Anybody seen this before? any suggestions for remedying the situation?
Roger Cotting
Tired of spam? Yahoo! Mail has the best spam protection around
|